Things have been progressing on the conversion. I've ended up spending more time fixing things on the Attex than working on the conversion. Bad axle bearings, bent axles, worn drive chains, and body cracks. The body cracks have been a real pain, ABS plastic isn't easy to repair in high stress areas. Unfortunately the body tub is pretty thin in the lower corners, where it should be the strongest. I've been using a combination of heat welding and ABS chips dissolved in acetone, with varying degrees of success. I will be making a skid plate out of heat formed HDPE plastic as a final reinforcement.
On the conversion side the motor mounts are just about done and I need to mount the contactor and controller.
I should have some pictures up soon.